Turning Scan On or Off
Press the preprogrammed Scan button to toggle
SCAN ON or SCAN OFF to initiate or stop scan.
If the scan is enabled, the display shows SCAN ON
and the scan status icon.
If the scan is disabled, the display shows SCAN OFF.
Making a Dynamic Priority Change
(Conventional Scan Only)
While the radio is scanning, the dynamic priority change
feature allows you to temporarily change any channel in a
scan list (except for the Priority-One channel) to the
Priority-Two channel.
This change remains in effect until scan is turned off. Scan
then reverts to the preprogrammed (original) setting.
• Making a Dynamic Priority Change using the
preprogrammed Dynamic Priority button:
a. When the radio locks onto the channel
designated as the new Priority-Two channel,
press the preprogrammed Dynamic Priority
button.
The radio continues scanning the remaining
channels in the list.
Deleting a Nuisance Channel
If a channel continually generates unwanted calls or noise
(termed “nuisance” channel), you can temporarily remove
the unwanted channel from the scan list.
This capability does not apply to priority channels or the
designated transmit channel.
NOTICE:
Deleting a nuisance channel is only possible
through the preprogrammed Nuisance Channel
Delete button.
When the radio is locked onto the channel to be
deleted, press the preprogrammed Nuisance Delete
button.
The radio continues scanning the remaining channels in
the list.
English
58
To Next Page
Loading...
