• If you select a single source zone, press the
Menu Select button directly below Sel to select
the target zones for cloning.
• If you select multi-source zones, the radio
displays Confirm target and shows the
automatically selected target zones and source
zones mapping.
5
Press the Menu Select button directly below Clon to
begin cloning.
The radio displays Cloning…<Current cloning zone>.
One of the following scenarios occurs:
• If the cloning is successful, a tone sounds, the radio
displays Clone successful and the source zone alias
is displayed on the right.
• If the cloning is not successful, a tone sounds and the
radio displays Clone failed. Press the Back button to
enter the source zone list.
• If you press the Home button, the radio aborts cloning.
NOTICE:
The target radio enters programming mode during
cloning and resets after cloning is completed.
Scan Lists
Scan lists are created and assigned to individual channels/
groups. Your radio scans for voice activity by cycling
through the channel/group sequence specified in the scan
list for the current channel/group.
Your radio supports different types of Scan Lists:
• Trunking Priority Monitor Scan List
• Conventional Scan List
• Talkgroup Scan List
Please refer to a qualified radio technician for the maximum
number of Scan Lists can be programmed in your radio.
These lists must be preprogrammed by a qualified radio
technician.
Intelligent Priority Scan
Intelligent Priority Scan feature allows you to add or delete
conventional channels and trunking talkgroups from
multiple system into the priority scan lists.
You can add or delete priority scan list members and
assign priorities using the preprogrammed Scan List
Programming button. Radio displays the priority level of
the scanned member.
English
56
To Next Page
Loading...
