11
Recommended Test
Equipment and Service Aids 4
Recommended
Test
Equipment
The list of equipment contained in Table 3 includes all of the standard test
equipment required for servicing two-way portable radios, as well as several
unique items designed specifically for servicing this family of radios. The
“Characteristics” column is included so that equivalent equipment may be
substituted; however, when no information is provided in this column, the
specific Motorola model listed is either a unique item or no substitution is
recommended.
Service Aids Refer to Table 4, “Service Aids,” for a listing and description of the service aids
designed specifically for servicing this family of radios. These kits and/or parts
are available from the Accessories and Aftermarkets Division offices listed in
the “Replacement Parts Ordering” section located on the inside back cover of
this manual. While all of these items are available from Motorola, most are
Table 3. Recommended Test Equipment
Motorola
Model Number
Description Characteristics Application
R2600 Series with
applicable options
Communications
System Analyzer
This monitor will substitute for
items with an asterisk (*).
Frequency/deviation meter and
signal generator for wide-range
troubleshooting and alignment.
Agilent 8901B Modulation Analyzer Transmitter parameter testing.
Deviation balance and limit for <2%
accuracy.
Fluke 8012 Digital Multimeter Recommended for ac/dc voltage
and current measurements
R1150_* Code Synthesizer Injection of audio and digital
signaling codes
R1377_* AC Voltmeter 1mV to 300V, 10-Megohm
input impedance
Audio voltage measurements
R1094_ Dual-Trace
Oscilloscope
20MHz bandwidth 5mV to
5V/division
Waveform measurements
R1443_* Wattmeter Fixed-Element, Broadband Transmitter power output
measurements
S1339_ RF Millivolt Meter 100µV to 3V RF RF-level measurements
R1013_* SINAD Meter Receiver sensitivity measurements
S1348_
(programmable)
DC Power Supply 0-20Vdc, 0-5 Amps
current limited
Bench supply for 7.5Vdc
To Next Page
Loading...
