Disassembly/Reassembly Procedures
40
Battery
NOTE: The Motorola-approved battery shipped with the
XTS 5000 radio is uncharged. Prior to using a new
battery, charge it for a minimum of 16 hours to
ensure optimum capacity and performance.
Attach the Battery 1. With the radio turned off, insert the top edge of the battery into
the radio’s frame as shown.
Figure 17. Insert the top edge of the battery
2. Rotate the battery toward the radio and press down until the
battery clicks into place.
Figure 18. Press the battery into place
Remove the Battery 1. With the radio turned off, press the release button on the bottom
of the battery until the battery releases from the radio.
Figure 19. Press the release button
To avoid a possible explosion:
• DO NOT replace the battery in an area labeled
“hazardous atmosphere.”
• DO NOT discard batteries in a fire.
If the radio is programmed with volatile-key
retention, encryption keys will be retained for
approximately 30 seconds after battery removal.