Recommended Test Equipment and Service Aids
12
standard shop equipment items, and any equivalent item capable of
the same performance may be substituted for the item listed.
Field Programming
Equipment
This family of radios can be aligned and programmed in the field. This
requires specific equipment and special instructions. Refer to the on-
line help in the Customer Programming Software (CPS) for complete
field programming information.
Table 4. Service Aids
Motorola Part
Number
Description Application
81-80384M64 Housing Eliminator Fixture Special fixture that allows radio’s internal board to be
mounted externally. Provides easy access to electronic
circuits, required for board-level troubleshooting.
58-80348B33 SMA to BNC Adaptor Adapts radio’s antenna port to BNC cabling of test
equipment.
66-85833D01 Housing/Casting Separation
Tool
Special tool used to separate housing and casting near
battery latch area for access to inside of radio.
NLN9839_ Vacuum Pump Kit Submersible radios only. Vacuum pump with gauge and
vacuum hose. Requires NTN9279_ Adapter Kit.
NTN4265_ Pressure Pump Kit Submersible radios only. Pressure pump with gauge and
pressure hose. Requires NTN9279_ Adapter Kit.
NTN9279_ Vacuum Adapter with Gasket
Kit
Submersible radios only. Connects the vacuum/pressure
hose to the radio’s casting.
REX4424_ Battery Eliminator Used in place of battery to connect radio to external power
supply.
RKN4105_ USB Cable Kit Connects radio to RLN-4460_ Portable Test Set for radio
performance checks, and to Universal Serial Bus (USB) port
on personal computer for CPS programming and tuner
alignments.
RKN4106_ RS232 Cable Kit Connects radio to RLN-4460_ Portable Test Set for radio
performance checks, and to serial port on personal
computer for CPS programming and tuner alignments.
RLN4460_ Portable Test Set Used for radio performance checks. Connects to radio’s
universal connector and allows remote switching and signal
injection/outputs for test equipment measurements.
RVN4181_ Customer Programming
Software (CPS) and Tuner
Software
CPS allows customer-specific programming of modes and
features. Tuner software required to perform alignment of
radio parameters. Can be used for both XTS 5000 and XTS
2500 products.
To Next Page
Loading...
