Motorola ASTRO XTS 5000 I - Page 76

Disassembly/Reassembly Procedures
52
6. Install the main seal o-ring (55) around the casting assembly (51).
7. Reassemble the housing assembly (2) to the radio.
8. Inspect the main seal (55) for proper seating. Observe carefully to
ensure that the main seal o-ring is not pinched between the
housing (2) and the casting (51).
Battery Contact and
Battery Contact Seal
1. Inspect the casting seal surface for debris or damage. Remove any
debris and replace casting if damaged.
2. Install the battery contact (49) and battery contact seal (50).
When installing the battery contact
seal, make sure that the ledge around
the outside of the seal completely
protrudes through the opening in the
casting and sits flush with the outside
surface of the casting. Also, make sure
that the seal’s shape is not distorted.
3. Reassemble the casting assembly (51).
4. Install the main seal o-ring (55) around the casting assembly (51).
5. Reassemble the housing assembly (2) to the radio.
6. Inspect the main seal (55) for proper seating. Observe carefully to
ensure that the main seal o-ring is not pinched between the
housing (2) and the casting (51).
!
C a u t i o n
Seal Ledge
Casting