Chapter 12
Monitor Feature
This feature allows you to monitor the activity of the current channel for both analog and digital mode.
NOTE: When the receive noise cancellation is turned on for analog mode, the "white noise" level during
monitor is softer.
12.1
Monitoring Channels
Procedure:
1. Press and hold the programmed Monitor button.
If the channel is in use:
● You hear radio activity.
● The green LED illuminates.
If the monitored channel is not in use:
● For analog channels, your radio sounds a "white noise".
● The green LED illuminates.
2. To call, press and hold the PTT button.
3. To listen, release the PTT button.
12.2
Sticky Monitor
The Sticky Monitor feature is used to continuously monitor a selected channel for activity.
12.2.1
Setting the Sticky Monitor
Procedure:
Press the programmed Sticky Monitor button.
Result:
When your radio enters the mode:
● A positive tone sounds.
● The green LED illuminates.
When your radio exits the mode:
● A negative tone sounds.
● The green LED extinguishes.
MN010576A01-AA
Chapter 12: Monitor Feature
29
To Next Page
Loading...
