Motorola HT1250-LS+

30
English
GETTING STARTED
SENDING A TRUNKED CALL
To send a trunked call:
SELECTING A CONVENTIONAL
ZONE AND CHANNEL
1 Hold the radio in a vertical
position at a distance of about
1 to 2 inches (2.5 to 5 cm)
from your mouth.
2 Press and hold the PTT button.
–or–
Press and release the PTT button and wait 3
seconds.
• If access to the trunked system was
successful, the LED indicator lights steady
red.
- In addition, your dealer can program
your radio to sound a short, high-
pitched (talk permit) tone, indicating
successful trunked system access.
• If access to the trunked system was
unsuccessful, the LED indicator flashes
red and a low-pitched (talk prohibit) tone
sounds, indicating that the system was
busy or out-of-range.
3 With the PTT button depressed, speak clearly
into the microphone.
4 Release the PTT button to listen.
You will see the Alias (if preprogrammed) or
MIN of the calling radio on your radio’s
display.
1 Use the Zone Selector knob to select the
appropriate conventional zone.
2 + or ? until you see the desired
conventional channel on the display.