Motorola HT1250-LS+

68
English
SCAN
•The G symbol appears on the display
when non-prioritized Auto Group Scan has
been activated.
•The H symbol appears on the display
when prioritized Auto Group Scan has
been activated.
• There is no LED indicator during Auto
Group Scan.
To Stop Auto Group Scan
Select a talkgroup that has not been
programmed for Auto Group Scan by your
dealer.
ALL GROUP SCAN G
(LTR TRUNKED OPERATION ONLY)
All Group Scan scans all talkgroups within the
selected LTR trunked zone.
When All Group Scan is enabled:
•The G symbol appears on the display.
• The LED indicator blinks green during All
Group Scan operation; it stops blinking
when the radio switches to an active talk-
group.
Note: If you enter menu mode while the radio is
scanning, scanning stops. It resumes when
you exit menu mode.
To Start or Stop All Group Scan Operation
through a Preprogrammed Button (see
page 16)
• Press the preprogrammed All Group Scan
button once to start All Group Scan.
• Press the preprogrammed All Group Scan
button again to stop All Group Scan.
–or–
To Start or Stop All Group Scan Operation
through the Menu
1 ) to enter menu mode.
2 + or ? until
3 ) to select
You see the current scan status.
4
+ or ? until
–or–
5 ) to confirm your selection.
$OO*URXS6FDQ
$OO*URXS6FDQ
$OO*URXS2Q"
$OO*URXS2II"