Motorola HT1250-LS+

69
English
SCAN
SYSTEM SCAN G
(LTR TRUNKED AND CONVENTIONAL
OPERATION)
System Scan scans trunked talkgroups and
conventional channels between LTR and
conventional zones, as programmed by your
dealer. Up to 16 different talkgroups or
conventional channels can be programmed
into each Scan list. You can edit these lists
through your radio’s menu (see page 70).
When System Scan is Enabled
•The G symbol appears on the display.
• The LED indicator blinks green during Sys-
tem Scan operation; it stops blinking when
the radio switches to an active talkgroup or
channel.
Note: If you enter menu mode while the radio is
scanning, scanning stops. It resumes when
you exit menu mode.
To Start or Stop a System Scan Operation
Press the preprogrammed Scan button (see
page 23) to start or stop scanning,
–or–
Do the following:
1 ) to enter menu mode.
2
+ or ? until
3 ) to select
You see the current scan status.
4 + or ? until
–or–
5 ) to confirm your selection.
Notes:
• In conventional zones only, if there is activ-
ity on a non-priority channel, the radio dis-
connects the user from the current
conversation and automatically switches to
an active priority channel. This is indicated
with a short alert tone.
• Your radio can either revert to a “selected”
channel or the “last active” channel
depending on its programming. For addi-
tional details, contact your local dealer.
6\VWHP6FDQ
6\VWHP6FDQ
6\V6FDQ2Q"
6\V6FDQ2II"