Motorola IT.6.1T - Room Monitor Functionality; Activating and Setting Receiver Unit

44
Room monitor
11. Room Monitor
YoucanuseyourIT.6Thandsettomonitorthesoundsinanotherroom.Ifthe
soundsreachacertainlevelthehandsetwillautomaticallydialouttoapre-
setexternalnumberortoanotherhandset.WhentheRoomMonitorisset
toOn,thehandsetwilldisplayRoomMonitorOnandonlythemicrophone
willbeactivetomonitorthesoundlevelsintheroom.Boththespeakerand
receiverwillbesettoOffandthehandsetwillnotringifthereisanincoming
call.
11.1 Switch Room Monitor On
1. Press Menu ,scrollto Room Monitor andpress OK .
2.
On ishighlighted,press OK .
3. Thehandsetreturnstoidlescreenandthedisplayshows
Room Monitor On .To
switchoffRoomMonitorpress
Off .
4. Press
toreturntostandby.
NOTE
If no receiver unit has been set (either an external number or additional
handset number) then the unit will beep and the display shows
Please set
receiving unit
.
11.2 Set the receiver unit
1. Press Menu ,scrollto Room Monitor andpress OK .
2. Scrollto
Call  To andpress OK .
3. Scrollto
Internal or External andpress OK .
Internal
1. Press
OK andtheregisteredhandsetwillbelisted,forexample“Handset
2 ”.
2. ScrollortoselectthehandsettheRoomMonitorwillcallifthenoise
levelsreachacertainlevel.
3. Press
OK .
NOTE
If only one handset is registered the display prompts
No additional HS and returns
to the previous screen. You must register additional handsets before the
handsets will be displayed and make Internal calls.
External
Either
1. Press
OK , Enter Number ishighlighted.
2. Press
OK ,entertheexternalnumberandpress OK .