EasyManuals Logo

Motorola MCS 2000 II User Manual

Motorola MCS 2000 II
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
page 16
MCS 2000 Models II & III 68P81083C49-B
programmed phone number. See your system admin-
istrator for further details.
Out of Range
If this optional function is programmed into your radio,
it will indicate when you have left your radio coverage
area. The display will alternate between
model III model II
and the current mode and/or the out of range tone will
sound.
Secure Operation
Note: This section applies only if secure operation is
programmed into your radio. This section lists fea-
tures where differences occur when operating in
secure. For other feature operation see General
Operation above.
Outgoing Calls: When the selected mode is not pre-
programmed as either secure-only or clear-only,
secure transmit is turned on/off by pressing the
secure button (4), except for trunking telephone inter-
connect and private call which are always controlled
by the button. A beep immediately after the PTT is
pressed indicates a clear (non-secure) transmission.
Note: If the secure button is pressed during a trans-
mission, the transmission is aborted, and an alert tone
will sound until the PTT is released. The operation
change will be effective with the next PTT press.
Incoming Calls: When a secure call is received the
orange LED (conventional only) and the secure icon
will flash.
Conventional Functions: In monitor, only calls from
radios with the same encryption key will be heard.
Calls with a different key will be heard as noise.
Trunking Functions: When secure transmit is control-
led by the secure button (4), during a talk group or
private call you can only change from clear to secure
operation. During a telephone interconnect or fail-
soft call you can change from clear to secure opera-
tion, or from secure to clear. During an emergency
call NO change is possible.
Secure Keyload and Erase
An encryption key must be loaded from a Key Variable
Loader (KVL) that corresponds to the encryption type
of the radio.
Disconnect the microphone cable from the control-
head and attach the keyloader cable. The display
shows “KEYLOADING”, and normal transmit and
OUT OF RANGE
SOUTH DIVISION
OUT OF RANGE
MCS2000 2&3-C UG GB (for US) Page 16 Monday, December 8, 1997 4:21 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Motorola MCS 2000 II and is the answer not in the manual?

Motorola MCS 2000 II Specifications

General IconGeneral
BrandMotorola
ModelMCS 2000 II
CategoryRadio
LanguageEnglish

Related product manuals