MCS 2000 Models II & III 68P81083C49-B
page 7
The dot in the scan icon flashes if the mode is
priority 1, lights continuously if the mode is prior-
ity 2 or the icon lights continuously to indicate a
normal priority mode. The programming icon will
be on while the list is viewed.
Use the mode selector (D) to view the next member.
The function is left by pressing the HOME button (3).
Changing Scan Lists
If a scan list is user programmable, it may be changed
by the user (members added or deleted).
Select the menu
PROGRAM LISTS
as previously
described, then use the mode selector (D) until
SCAN
is displayed and press the select button (13) or
Press and hold the scan button (8) until the key press
accepted tone is heard. The programming icon
and the triangle in the display flash.
Use the mode selector (D) to select the desired mode.
Press the select button (13) if the scan icon is not
in the display, to include the mode as a normal priority
member.
Press the select button again to make the mode prior-
ity 2 (the scan icon lights continuously).
Press the select button a third time to make it a prior-
ity 1 mode (the dot in the scan icon flashes).
Pressing the select button again makes the mode
non-member (mode not included in the list).
Telephone Interconnect
Telephone interconnect is used when the radio is
required to operate in a radio system connected to a
public or private telephone system.
Receiving a Telephone Call
When your radio receives a telephone call, a tele-
phone ringing tone sounds and the display alternates
between
model III model II
and the home display. The green indicator (B) and the
call received icon flash.
Press the phone button (7) to answer the call.
Press the HOME button (3) or the menu button (9)
when the conversation is over.
Sending a Telephone Call
List Selection
Press the menu button (9) and operate the mode
selector (D) until
PHONE
is displayed. Press the select
PHONE CALL
SOUTH DIVISION
PHONE CALL
MCS2000 2&3-C UG GB (for US) Page 7 Monday, December 8, 1997 4:21 PM