page 4
MCS 2000 Models II & III 68P81083C49-B
Depending on programming, if the ignition is turned
off, the radio will:
• turn off
• inhibit transmit capability, or
• inhibit the use of the PTT button.
Contact your system operator for further information.
Turn the radio off by pressing the on/off button (A)
again.
Note
: If the radio sounds the error tone and dis-
plays an error message, please contact the per-
son in charge of your radio system or your local
service representative.
Function Selection
Functions programmed into the radio can be selected
in two different ways:
1 Directly via a pre-programmed, dedicated but-
ton, or
2 Indirectly via the radio MENU.
Function Button Selection
For direct access to a feature, depress the desired
function button.
A triangle in the display points to the function button
used.
If the function requires additional input, use the mode
selector (D) to display your choices, and press the
select button (13).
Note
: Function buttons are usually active.
Pressing a function button will exit the current
feature and start the selected feature.
Menu Selection
Features may be accessed indirectly through the radio
menu.
1 Press the menu button (9) to enter menu selec-
tion.
2 Use the mode selector (D) to display the desired
function.
3 Press the select button (13). The radio will leave
menu mode and enter the selected feature, or
enter a sub-menu.
MCS2000 2&3-C UG GB (for US) Page 4 Monday, December 8, 1997 4:21 PM
To Next Page
Loading...
