MAINTENANCE MTM700 Mobile Radio / Detailed Service Manual 7 - 5
Radio Disassembly and Reassembly - Detailed
The procedure to remove and replace a Control Head, Top Cover or Transceiver Board is similar for
all models of radio. A typical procedure is therefore shown followed by specific disassembly
procedures for Control Heads or Expansion Heads on radio models
Control Head Removal
1. Insert the dismantling tool in the groove between the control head and the radio assembly as
shown in the Figure.
2. Press on the dismantling tool until the snap connectors on the side of the control head release
from the radio assembly.
3. Pull the control head away from the radio assembly as shown below.
Figure 1 Typical Control Head Removal
Dismantling
Tool
ZWG0130209-O
To Next Page
Loading...
