Motorola MTM700

7 - 12 MTM700 Mobile Radio / Detailed Service Manual MAINTENANCE
Remote Mount Head - Reassembly
To Reassemble the Remote Front Housing:
1. Connect the flex from the Remote Front Housing to the top small connector in the
Transc eive r.
2. Press the Remote Front Housing onto the Transceiver chassis until the chassis tabs
snap into
place.
To Reassemble the Remote Back Housing
1. Connect the flex from the Remote Back PCB to the Controlhead.
2. Depending on the arrangement, orientate the Controlhead in the Back Housing
3. Press the Controlhead onto the Remote Back Housing until ALL 6 tabs snap into place.
NOTE:
For correct orientation of the flex in the Transceiver, the “plastic” tab should be up,
contacts facing down. Align the ‘dot’ or ‘O’ marking on the flex with the ‘O’ mark on
the Transceiver. The
flex must be pushed into the connector until it meets the stop.
NOTE:
For correct orientation of the flex align the ‘dot’ or ‘O’ marking on the flex with the ‘O’
mark on the PCB.
NOTE:
The flex is not designed for continuous insertion, replace after several uses.