Motorola MTM700

9.1 - 18 MTM700 Mobile Radio / Detailed Service Manual TROUBLESHOOTING CHARTS (400MHz)
Main VCO Troubleshooting
Failure:
VCO signal level at TP5702 < -5dBm
Yes
Tetra Com Script for RX Test
TEST_ENTER
DELAY 10
Check for "Radio HW is READY"
MODE IDLE
FREQ RX 405.025
L1TIMER ON
AVE 10
MODE RSSI
GO
Use STOP to terminate RSSI reading
Connect the radio's accessory connector to the Tetra Com interface.
Connect the radio's antenna connector to the high power RF output
on the IFR.
Connect the 50 ohms RF probe to the low power RF input on the IFR.
Setup IFR:
Select high power output and low power input.
No System,
TX Test,
TX Frequency 331.675MHz
Spectrum Analyser
Set Reference Level to 10dBm.
Run Tetra Com script for RX test.
Measure RF levels and frequencies with the 50ohms RF probe.
Measure DC levels with a multimeter.
0.6V DC at
U5701 pin 6
?
Yes
No
4.6V DC at
C5343
?
No
Yes
Check components between
U5701 pin 5 & 6 and TP5701
3.3V DC at
U5701 pin 14 & 18
?
Yes
No
Replace
U5701
Check for 9.3V at
U5321 pin 1 & 3
before replacing
U5321
5V DC at U5331
pin 30
?
No
Replace
U5331
Check for 9.3V at
U5322 pin 3 &
6 and L5301 before
replacing U5321
Start
ZWG0130966-O