102
This estimate of accuracy of the calculated location is only a
very rough estimate and may vary substantially from the
actual accuracy of the approximate location information
reported.
Viewing Your Position
1. From the main menu, press Menu and
select More... > Location > Position.
2. Scroll to view the entire screen.
This displays the following information
about the last time your location was
calculated (if available):
• The time the location was last calculated
• The latitude expressed in degrees, minutes, and seconds
• The longitude expressed in degrees, minutes, and
seconds
• The number of satellites used to calculate the location. In
general, more satellites make for better accuracy. The
maximum is twelve satellites.
To calculate your location again, press Refresh.
For the users from United Kingdom and
Ireland there are two letters (for UK) or 1
letter (for IRL) displayed. This feature
needs to be enabled by the Service
Provider.
This feature works in DMO and TMO modes when it is set by the
Service Provider.
The variation will vary in accordance to the GPS Configuration
set by your Service Provider.
The availability of the GPS Location menus is dependent on
your terminal configuration, please contact your Service
Provider for further details.
13:41:59
N: 35°59.9814
E: 140°00.0000
Sats Used: 4
Back
Rfrsh
Position
13:41:59
<LocationLetter>
N: 35°59.9814
E: 140°00.0000
Sats Used: 4
Back
Rfrsh
Position
To Next Page
Loading...
