55
Receiving a DMO Group Call
You can receive a DMO Group Call only when your
MTM800E is in DMO.
Your MTM800E will display the caller’s private number or
alias, and the talkgroup name.
The following screens show examples of how the caller’s
identity can be displayed.
Receiving a DMO Group Call (MS - MS)
When an InterMNI call is received, you can press Network to
see the Network alias and/or number.
If Gateway and Repeater mode is selected, and if one of the
devices is not available, the call setup is proceeding as if this
device was not selected.
Example
: In case of the Gateway is available and the Repeater
is not available, after an unsuccessful Gateway call attempt the
call falls back to MS - MS mode immediately with the MS-MS
Call message.
For call alert, see settings in the Tones menu option (page 123)
.
Without alias and
Private ID
Private ID
without alias
Private ID
with alias
Open Group Call InterMNI Call
Group in Use
Folder 1
TG4
Folder
Optns
Group in Use
ID:124
TG4
Folder
Optns
Group in Use
ID:David
TG4
Folder
Optns
OR OR
OR
Group in Use
ID:David
Open Group
Folder
Optns
Group in Use
ID:...124
TG4
Folder
Optns
To Next Page
Loading...
