Motorola MTM800E - Silent Emergency Mode; Entering Silent Emergency Mode; Exiting Silent Emergency Mode; Silent Emergency Mode Interactions

69
Emergency Operation
Emergency Operation
General
Emergency Operation is available in TMO and in DMO, if the
MTM800E is in service.
Emergency Mode indication (alert tones) can be disabled by
your Service Provider.
Entering TMO or DMO
See “Selecting TMO or DMO Operation” on page 23.
Important Information
• The required time you need to press the Emergency button is
set by default to 0.5 seconds. The time can be configured by
your Service Provider.
• Pressing the Emergency button can be used to activate one
or more services:
- Emergency Mode
- Sending Emergency Alarm
- Starting Hot Mic operation
- Starting emergency individual call
- Powering up the terminal
- Sending the GPS location infromation, if this option is
enabled by your Service Provider
• Pressing the Emergency button even if Transmit Inhibit is
activated causes immediately the MTM800E to transmit.
When entering Emergency Operation the MTM800E should
not be within the RF sensitive area any longer!
• The MTM800E interrupts the AL call when you press the
Emergency button.
• For call alerts, see settings in the Tones menu option
(page 123)
.