Motorola MTM800E - Page 122

114
PIN Protect
Network access protection is configured by your Service
Provider:
• No access to network operation
– you can only send or
receive Emergency Calls and adjust the volume level. Unit
lock takes effect at the next power on.
To protect access to network operation:
1. From the main menu, select Security > PIN Protect. On is
highlighted.
2. Press Select.
3. At the Code prompt enter the 4-digit code (factory setting
0 0 0 0). To avoid disclosure of the code, asterisks are
displayed instead of the code digits. The display will show
the following message:
Unit Locked
– you entered the correct code. The display
returns to the Security sub-menu and shows the active
setting: On
.
To unlock the MTM800E before powering off:
1. From the main menu, select Security > PIN Protect. Off is
highlighted.
2. Press Select.
3. At the Code prompt enter the 4-digit code.The display will
show the following message:
Unit Unlocked
– you entered the correct code. The display
returns to the Security sub-menu and shows the active
setting: Off
.
To unlock the MTM800E after powering on, enter the code at
the prompt. The MTM800E enters the Home display.
If you fail to enter the correct code, the following message will
be displayed:
Incorrect Code Entered
– you are prompted to try again.
After failing, your MTM800E will be blocked. Please check
with your Service Provider how many failed attempts are
allowed.