132
Set Scanning to On
Scanning is Off. Select On. A message
may indicate that all scan lists are empty.
Select Scan Lists to fill the scan list(s).
The display shows the following state:
Then, the display shows (for example)
the Scanning Scan List 1 message.
The terminal will then try to attach to this list.
Set Scanning to Off
Scanning is on. Select Off. The display
shows the following state:
Then, the display shows the Scanning
is Off message.
Selecting a List with Scanning On
1. Select Select List.
2. To select a list other than the
highlighted one, scroll and press
Select. The display shows (for
example) the Scanning Scan List 1
message. The terminal will then try to
attach to this list.
Selecting a List with Scanning Off
1. Select Select List.
2. To select a list other than the highlighted one, scroll and
press Select. The display shows (for example) the Scan
List 1 Selected message.
The Network List
Your terminal can scan (and attach) to a list belonging to
another infrastructure than the Dimetra infrastructure:
• Upon pressing Select, if the Network List is selected, only
this list will attach. If a user list is selected, then both the
Network List and the user list will be attached.
Back
Select
On
Select List
Scanning
Back
Select
Off
Select List
Scanning
Back
Select
Scan List1
Scan List2
No List
Scan Lists
To Next Page
Loading...
