134
Editing Scan Lists
1. From the main menu, select More...
> Group Setup > Scan > Scan Lists.
2. Scroll to the required scan list. Press
View to see the groups used in the
scan list. Press Back to return to the
previous display.
3. To edit/view the contents of a scan list,
press Menu
.
4. In the List Optns sub-menu, scroll to
the required option and press Select.
• Rename the active scan list. (For details on text editor
use, see “Writing Text” on page 167.). Enter a new
name (alias) and press Ok. The display shows the new
setting.
•Check
the capacity of the active scan list (number of
groups stored in the list).
•To Clear all groups from the selected scan list, press
Yes. You will be prompted to remove all groups from the
selected scan list.
• Add a group to the selected scan list. Every added
group (including a favourite group) comes with its folder,
its name or number, and its priority (if pre-programmed).
> To select a folder, scroll through the folder list. The list
does not show folders whose groups are fully used in
the selected scan list. Press Ok to select a folder.
> To select a group, scroll through the group list within
the selected folder. The list shows groups that are not
in the selected scan list. Press Ok.
The options below cannot be used for the Network List.
If the Network List is empty, it will not be displayed.
Back
View
Scan List1
Scan List2
Scan List3
Scan List4
Scan List5
Scan List6
Scan Lists
Back
Select
Rename
Capacity
Clear
Add Group
Edit
List Optns
To Next Page
Loading...
