46
If the DGNA message is received to
delete all Talkgroups, your MTM800E will
display the following:
DGNA Reception without Notification
Message
If DGNA notification was not configured by your Service
Provider, you will get a tone indication and notification
message only and only if a selected group was changed by
the DGNA.
DGNA Auto Select Group
If DGNA Auto Select was configured by your Service
Provider, whenever a DGNA message is received by your
terminal, the talkgroup will automatically be made the
selected group by your terminal.
Button/Footswitch
This feature provides to the user ability to send preset status
message by pressing the button/footswitch. In TMO mode,
the ability to send an Alarm and initiate a TMO Group/Private
call is unavailable.
Message addressing and sending:
• the address can be predefined by the Service Provider, if
not it is sent to currently selected group
• if no group is selected the message is sent to the reserved
address
• message is sent even if the user is involved in any active
call.
The indication depends on the setting from the Service
Provider. Visible/audible indications can be disabled for the
status message.
When the radio is PIN locked the user can still press the
Button/Footswitch to send the message.
If the radio is out of service the user will only see indication
that the operation failed.
All Talkgroups Deleted
Back
To Next Page
Loading...
