50
Selecting DMO Group Call via Gateway
While in DMO, proceed as follows to choose a gateway to set
up a call via Gateway for the selected talkgroup:
1. Press Optns, scroll to Config and press Select.
2. Scroll to Gateway and press Select.
3. The display shows the last gateway selection method. Use
the navigation key to scroll to your selection and press Ok:
Automatic
– the MTM800E will use the
first available gateway for that
talkgroup. The Gateway icon will flash
upon selecting that option.
Specific
– the MTM800E will use only
the gateway with the specified
Gateway address for that talkgroup.
Upon selecting “Specific”, you will see one of the following
displays:
• The selected gateway address (e.g.:
1022), pre-programmed by your
Service Provider or previously
entered by yourself via the keypad.
Press Edit and then Ok to use the
current address, or enter a new
address via the keypad, and press Ok. The Gateway
icon will flash upon selecting the gateway.
• “None”, indicating that no gateway
was selected for that talkgroup.
Press Edit and enter an address via
the keypad, Press Ok. The Gateway
icon will flash upon selecting the
gateway.
When the MTM800E detects the suitable
gateway, the Gateway icon will turn solid.
Automatic
Specific
Back
Select
Config
Seleted Gateway:
1022
Back
Edit
Seleted Gateway:
None
Back
Edit
DMO Folder 1
Police
Hello
Contcs
Optns
To Next Page
Loading...
