5-1
5
5Pin Assignments
Connector Pin Assignments
This chapter summarizes the pin assignments for the following groups of
interconnect signals on the MVME162P4:
The tables in this chapter furnish pin assignments only. For detailed
descriptions of the interconnect signals, consult the support information
for the MVME162P4 (available through your Motorola sales office).
IndustryPack A, B, C, D Connectors
Up to four IndustryPack (IP) modules may be installed on the
MVME162P4. For each IP module, there are two 50-pin plug connectors
on the board:
❏ Module A, J4/5
❏ Module B, J10/11
❏ Module C, J20/21
❏ Module D, J29/30
Connector Location Table
IndustryPack A, B, C, D connectors J4/5/8, J7/10/11,
J20/21/27, J26/29/30
Table 5-1
Remote Reset connector J6 Table 5-2
Serial port module connector J15 Table 5-3
Serial Port 2 connector J18 Table 5-4
Serial Port 1 connector J25 Table 5-5
VMEbus connector P1 P1 Table 5-6
VMEbus connector P2 P2 Table 5-7
To Next Page
Loading...
