Preparing the Board
http://www.motorola.com/computer/literature 1-5
1
MVME162P4 Configuration
Figure 1-1 illustrates the placement of the jumper headers, connectors,
configuration switches, and various other components on the
MVME162P4. Manually configurable jumper headers and configuration
switches on the MVME162P4 are listed in the following table.
J3 is a PLD programming header for lab or factory use. It has no user
function.
Table 1-2. MVME162P4 Configuration Settings
Function Factory Default
VME System Controller (J1) on page 1-7
2-3
IP Bus Clock (J14) on page 1-8
1-2
SIM Selection for Serial Port B (J15) on page 1-9
SIMM06
Serial Port 1/Console Clock (J16) on page 1-12
No Jumpers
Serial Port 2 Clock (J17) on page 1-12
No Jumpers
IP Bus Strobe (J19) on page 1-13
No Jumper
SRAM Backup Power Source (J22) on page 1-13
1-3, 2-4
EPROM Size (J23) on page 1-14
2-3
Flash Write Protection (J24) on page 1-15
Jumper On
MC2 DRAM Size (S3) on page 1-15
Off-Off-Off
General-Purpose Readable Switch (S4 Pin 5) on page 1-17
On
IP DMA Snoop Control (S5 Pins 1/2) on page 1-18
On-On
IP Reset Mode (S5 Pin 3) on page 1-19
On
Flash Write Enable Mode (S5 Pin 4) on page 1-20
On
MCECC DRAM Size (S6) on page 1-21
On-Off-On
To Next Page
Loading...
