xvi
Summary of Changes
This is the second edition of MVME162P4 Installation and Use. It
supersedes the June 2000 edition and incorporates the following updates.
Overview of Contents
Chapter 1, Hardware Preparation and Installation, provides unpacking
instructions, hardware preparation guidelines, and installation instructions
for the MVME162P4 VME Embedded Controller.
Chapter 2, Startup and Operation, provides information on powering up
the MVME162P4 VME Embedded Controller after its installation in a
system and describes the functionality of the switches, status indicators,
and I/O ports.
Chapter 3, 162Bug Firmware, describes the basics of 162Bug and its
architecture, describes the monitor (interactive command portion of the
firmware) in detail, and gives information on using the debugger and
special commands.
Chapter 4, Functional Description, describes the MVME162P4 VME
Embedded Controller on a block diagram level.
Date Description of Change
October 2000 In the description of the snoop control switch on page 1-18, entries in the table
concerning boards equipped with the MC68060 processor have been corrected.
October 2000 Several jumper drawings and configuration descriptions in Chapters 1 and 2
have been updated to reflect the current board layout and shipping
configuration.
October 2000 Drawings pertaining to MVME712A/AM/-12/-13 series transition boards have
been deleted from the illustrations of serial connections at the end of Chapter 1,
as those boards are out of production. References to them in the Serial
Communications Interface section of Chapter 4 have been dropped as well.
October 2000 In the descriptions of the MC2 and MCECC DRAM size switches on pages
1-15 and 1-21, the importance of executing env;d after modifying switch
settings has been emphasized.
To Next Page
Loading...
