Motorola MVME162P-344SE - APPENDIX D Disk;Tape Controller Data; Controller Modules Supported

D
D-1
DDisk/Tape Controller
Data
Controller Modules Supported
The following VMEbus disk/tape controller modules are supported by the
162Bug. The default address for each controller type is First Address. The
controller can be addressed by First CLUN during execution of the
BH,
BO, or IOP commands, or during execution of the .DSKRD or .DSKWR
TRAP #15 calls. Note that if another controller of the same type is used,
the second one must have its address changed by its onboard jumpers
and/or switches, so that it matches Second Address and can be called up by
Second CLUN.
Controller Type
First
CLUN
First
Address
Second
CLUN
Second
Address
CISC Embedded Controller
$00 (Note 1) -- -- --
MVME320 - Winchester/Floppy
Controller
$11 (Note 2) $FFFFB000 $12 (Note 2) $FFFFAC00
MVME323 - ESDI Winchester
Controller
$08 $FFFFA000 $09 $FFFFA200
MVME327A - SCSI Controller
$02 $FFFFA600 $03 $FFFFA700
MVME328 - SCSI Controller
$06 $FFFF9000 $07 $FFFF9800
MVME328 - SCSI Controller
$16 $FFFF4800 $17 $FFFF5800
MVME328 - SCSI Controller
$18 $FFFF7000 $19 $FFFF7800
MVME350 - Streaming Tape
Controller
$04 $FFFF5000 $05 $FFFF5100
Notes:
1. If an MVME162P4 with an SCSI port is used, the MVME162P4 module has CLUN 0.
2. For MVME162P4s, the first MVME320 has CLUN $11; the second MVME320 has CLUN $12.