14 6/29/98
StarTAC 3000
40# RCVVC Receive one voice channel word (wide mode only).
When the word is received it is displayed in hex. This
command will be complete when a voice channel word
is received or when the # key is entered to abort the
command.
41# -44# (NOT USED)
45# READ RSSI Returns the RSSI reading taken on the current channel.
The number is displayed as a three digit decimal
number.
46# (NOT USED)
47A# AUDLEV Set audio level where A = level (0 = lowest,
15=highest). The normal level is 2.
NOTE: Use 8 to 15 only for DTMF applications.
48# SIDETONE ON Enable sidetone. (Command 05# must also be
executed)
49# SIDETONE
OFF
Disable sidetone. (Command 06# must also be
executed)
50# - 54# (NOT USED)
55# DISPLAY/
PROGRAM
NAM
NAM Displays the contents of the NAM, one step at a time,
advanced by depressing the
*
key. Only the last 7 digits
of data are displayed.
56# AUTO-CYCLE Radio will alternate between transmit/display and
standby. Transmits on channel 991. Exit by pressing #
key.
57A# CALL
PROCESSING
MODE
A = 1 to enter narrow (NAMPS) mode
A = 0 to return to wide (AMPS) mode
The phone defaults to wide mode on power up.
58# COMPANDOR
ON
Turn compandor ON.
59# COMPANDOR
OFF
Turn compandor OFF.
60# & 61# (NOT USED)
62# RNG-ON Turn the APC ringer audio output path ON.
63# RNG-OFF Turn the APC ringer audio output path OFF.
64# PLT-ON Turn the APC transmit pilot path ON.
65# PLT-OFF Turn the APC transmit pilot path OFF.
66# ID TRANSFER Reserved for Identity Transfer Procedure.
67# (NOT USED)
Table 3: Test Commands For Manual Test Mode
Keypad
Entry
Command
Description
Status
Display
Result
To Next Page
Loading...
