9-8
Symbol LS9208 Product Reference Guide
Convert All Bar Codes to Code 39
By default, the Wand Emulation Interface sends data to the attached host in the same
symbology that was decoded. This may present a problem for customers with legacy
systems that do not recognize some newer symbologies (for example, RSS).
Enabling this parameter ignores the original symbology that was decoded, and outputs the
data as if it were a Code 39 barcode. Any lowercase characters that were in the original
data stream are transmitted as uppercase characters. This also allows ADF Formatting to
occur.
If Ignore Unknown Characters is enabled, any characters that do not have a corresponding
character in the Code 39 symbology set are replaced by a space.
If Ignore Unknown Characters is disabled, if any characters that do not have a
corresponding character are encountered, the scanner emits an error beep and no data is
transmitted.
ADF Note: By default, the Wand Emulation Interface does not allow scanned data to be
processed by ADF rules. Enabling this parameter has the side effect of allowing the
scanned data to be processed by the ADF rules (See Chapter 13).
Enable Convert to Code 39 for Wand Host
*Disable Convert to Code 39 for Wand Host
To Next Page
Loading...
