13-7
Advanced Data Formatting
Special Commands
Pause Duration
This parameter allows a pause to be inserted in the data transmission. Pauses are set by
scanning a two-digit number (i.e., two bar codes), and are measured in 0.1 second
intervals. For example, scanning bar codes “0” and “1” inserts a 0.1 second pause; “5” and
“0” gives you a 5 second delay. Numeric bar codes begin on page D-1 in Numeric Bar
Codes. If you make an error or wish to change your selection, scan Cancel bar code on
page 12-11. The default for Pause Duration is 1 second.
Pause Duration
Begin New Rule
Scan this bar code to start entering a new rule.
Begin New Rule
To Next Page
Loading...
