6809493A69-O May 18, 2005 33
Level 1 and 2 Service Manual Disassembly
10. Insert and tighten the two T6 display bracket screws to torque setting of
16 Ncm.
11. Place the display assembly into the flip housing and gently press down until
all the catches are engaged and the flip display lens is flush with the flip
housing.
12. Insert and tighten the two T6 flip assembly screws to a torque setting of
16 Ncm. Do not overtighten.
13. Replace the flip assembly bezel, flip assembly, transceiver board assembly, rear
housing, antenna cap, SIM, battery, and battery cover as described in the
procedures.
To Next Page
Loading...
