1
English
M
XT660d Two-Way Radio Quick Start
Guide
SAFETY
RF Energy Exposure and Product
Safety Guide for Portable Two-Way
Radios
ATTENTION!
Before using this product, read the RF Energy
Exposure and Product Safety Guide that ships
with the radio which contains instructions for
safe usage and RF energy awareness and
control for compliance with applicable
standards and regulations.
For downloading the full version of this user
guide and for a list of Motorola Solutions-
approved batteries and other accessories, visit
the following website:
http://www.motorolasolutions.com
BATTERIES AND CHARGERS
SAFETY INFORMATION
This document contains important safety and
operating instructions. Read these instructions
carefully and save them for future reference.
Before using the battery charger, read all the
instructions and cautionary markings on
• the charger,
• the battery and
• the radio using the battery
1 To reduce risk of injury, charge only the
rechargeable Motorola Solutions-authorized
batteries. Other batteries may explode,
causing personal injury and damage.
2 Use of accessories not recommended by
Motorola Solutions may result in risk of fire,
electric shock, or injury.
3 To reduce risk of damage to the electric plug
and cord, pull by the plug rather than the
cord when disconnecting the charger.
4 An extension cord should not be used
unless absolutely necessary. Use of an
improper extension cord could result in risk
of fire and electric shock. If an extension
cord must be used, make sure that the cord
size is 18AWG for lengths up to 6.5 feet (2.0
m), and 16AWG for lengths up to 9.8 feet
(3.0 m).
5 To reduce risk of fire, electric shock, or
injury, do not operate the charger if it has
been broken or damaged in any way. Take it
to a qualified Motorola Solutions service
representative.
6 Do not disassemble the charger; it is not
repairable and replacement parts are not
available. Disassembly of the charger may
result in risk of electrical shock or fire.
7 To reduce risk of electric shock, unplug the
charger from the AC outlet before attempting
any maintenance or cleaning.
OPERATIONAL SAFETY GUIDELINES
• Turn the radio OFF when charging battery.
• The charger is not suitable for outdoor use.
Use only in dry locations/conditions.
• Connect charger only to an appropriately
fused and wired
• supply of the correct voltage (as specified on
the product).
• Disconnect charger from line voltage by
removing main plug.
• The outlet to which this equipment is
connected should be nearby and easily
accessible.
• Maximum ambient temperature around the
power supply equipment must not exceed
40°C (104°F).
• Make sure that the cord is located where it
will not be stepped on, tripped over, or
subjected to water, damage, or stress.
For information on the battery and charging
procedures, refer to the “Batteries and
Chargers” section of the User Guide.
Radio Overview
Control Buttons Reference Numbers
1. Antenna
2. Loop hole for strap
3. Recording Button
4. PTT Button
5. Side Button 1
6. Side Button 2
7. On/Off/Volume Knob
8. LED
7
8
9
10
11
12
6
5
4
3
2
1
13
14
15
16
To Next Page
Loading...
