EasyManuals Logo

Moxa Technologies EtherDevice EDS-510A Series Hardware Installation Guide

Moxa Technologies EtherDevice EDS-510A Series
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
- 12 -
Turbo Ring DIP Switch Settings
EDS-510A series are plug-and-play managed redundant Ethernet switches. The
proprietary Turbo Ring protocol was developed by Moxa to provide better
network reliability and faster recovery time. Moxa Turbo Ring’s recovery time
is less than 300 ms (Turbo Ring) or 20 ms (Turbo Ring V2) —compared to a
3- to 5-minute recovery time for commercial switches—decreasing the possible
loss caused by network failures in an industrial setting.
There are 4 Hardware DIP Switches for Turbo Ring on the top panel of
EDS-510A that can help setup the Turbo Ring easily within seconds. If you do
not want to use a hardware DIP switch to setup the Turbo Ring, you can use a
web browser, telnet, or console to disable this function.
NOTE
Please refer to the Turbo Ring DIP Switch section and Using
Communication Redundancy section in User’s Manual for more
detail information about the settings and usage of Turbo Ring and
Turbo Ring V2.
EDS-510A Series DIP Switches
21
------
MASTER
COUPLER
TURBO
RING
43
The default setting for each DIP Switch is OFF. The
following table explains the effect of setting the DIP
Switch to the ON position.
“Turbo Ring” DIP Switch Settings
DIP 1 DIP 2 DIP 3 DIP 4
ON: Enables this
EDS as the Ring
Master.
ON: Enables the
default “Ring
Coupling” ports.
ON: Activates
DIP switches 1,
2, 3 to configure
“Turbo Ring”
settings.
Reserved for
future use.
OFF
: This EDS
will not be the
Ring Master.
OFF
: Do not use
this EDS as the
ring coupler.
OFF
: DIP
switches 1, 2, 3
will be disabled.
“Turbo Ring V2” DIP Switch Settings
DIP 1 DIP 2 DIP 3 DIP 4
ON: Enables the
default “Ring
Coupling
(backup)” port.
ON
: Enables this
EDS as the Ring
Master.
ON
: Enables the
default “Ring
Coupling” port.
ON
: Activates
DIP switches 1,
2, 3 to configure
“Turbo Ring V2”
settings.
OFF: Enables the
default “Ring
Coupling
(primary)” port.
OFF
: This EDS
will not be the
Ring Master.
OFF
: Do not use
this EDS as a
ring coupler.
OFF: DIP
switches 1, 2, 3
will be disabled.

Other manuals for Moxa Technologies EtherDevice EDS-510A Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Moxa Technologies EtherDevice EDS-510A Series and is the answer not in the manual?

Moxa Technologies EtherDevice EDS-510A Series Specifications

General IconGeneral
BrandMoxa Technologies
ModelEtherDevice EDS-510A Series
CategorySwitch
LanguageEnglish

Related product manuals