mr
.
steamsteambaths
®
tempo controls
24
Tempo/Plu
™
Operating Instructions
The Tempo/Plus Control features programmable digital temperature control, pro-
grammable time duration, ON/OFF and PAUSE and two personal settings storage.
ON/OFF - Diagram 1
Press the ON/OFF key to start or stop the flow of steam.
Steam will begin to flow a few minutes after the control is turned ON. The dura-
tion required for the steamroom to reach steambathing temperatures depends on
the steamroom construction and steam generator specifications. Steam may con-
tinue to flow for a short time after the control is turned OFF.
PAUSE feature - Diagram 2
If a pause in steam flow is desired press the PAUSE key. The display will flash while
the control is in the P
AUSE mode. The timer will continue to countdown while in
the PAUSE mode.
Setting the time duration - Diagram 3
Press
TIME key to set or display the remaining relaxation time.
The control is pre-set and will display a TIME setting of 20 minutes
(default setting).
With the TIME displayed, press the UP and DOWN keys (Diagram 4) to set the
desired duration time (2 - 60 minutes) in two minute increments.
Set the steambathing duration according to personal preference, however it is
highly recommended to begin steambathing at a shorter duration to
gauge comfort and safety levels.
The control will turn off when the relaxation period times out.
Setting the temperature
Press TEMP key to set the desired temperature or display the temperature setting.
The control is pre-set and will display a temperature setting of 110˚F (default set-
ting).
W
ith the temperature displayed, press the UP and DOWN keys (Diagram 4) to set
the desired temperature (105˚F to 120˚F) in one degree increments.
Set the steambathing temperature according to personal preference, however it is
highly recommended to begin steambathing at a low temperature setting to gauge
comfort and safety levels.
Memory feature
If the control is turned off manually before it times out then the default settings
of 20 minutes and 110˚F will be used the next time the control is turned on. If the
control times out (not manually turned off) then the previous user time and tem
-
perature settings will be used when the steambath is used again.
PROG 1 and PROG 2 feature
PROG 1 and PROG 2 keys program and store preferred settings.
To program preferred settings: Press a PROG1 or PROG2 key. Enter the preferred
time and temperature settings. The TEMPO/PLUS will store these settings.
To select PROG1 or PROG2 : Press ON then press PROG1 or PROG2. The steambath
will begin to operate at the stored settings.
DIAGRAM 1
DIAGRAM 2
DIA
GRAM 3
DIAGRAM 4
To Next Page
Loading...
Need help?
General
