* Power quality analyzer for single-phase or balanced three-phase system.
* Voltage and Current are the True RMS value.
* ACV input impedance is 10 Mega ohms.
* True Power(KW、MW、GW) measurement.
* Apparent Power (KVA、MVA、GVA) measurement.
* Reactive Power (KVAR、MVAR、GVAR) measurement.
* Power Factor (PF)、Phase Angle ( ∮ ) measurement.
* Energy(KWh、KVAh、KVARh、PFh) measurement.
* Voltage measurement range: 10 to 600 ACV
* Current measurement range: 5 to 2000 ACA
* Graphic Phasor Diagram.
* Voltage and Current harmonic analysis (1-50th order).
* Voltage and Current Total Harmonic Distortion analysis (THD)
* Voltage and Current waveforms show.
* Peak-to-Peak voltage and current measurement.
* Capture Transient events (including Dip, Swell and Outage ) with
programmable threshold ( % ).
* Thermocouple Temp. sensor:Type K(-100.0℃〜199.9℃/200℃〜1300℃),℃/℉.
* Programmable PT ratio ( 1 to 1000 ).
* Safety Standard : IEC 1010, CAT IV 600V.
* Built-in clock and Calendar, real time data record with micro SD memory card ,
sampling time set from 2 to 7200 seconds. Just slot in the micro SD card
into the computer, it can down load the all the measured value with
to the Excel directly, then user can make the further data analysis by themselves.
* micro SD CARD 32 GB maximum supported capacity.
* Powered by AA ( UM-3 ) DC 1.5 V X 2 batteries ( Alkaline type ) or
DC 9V adapter. (linear 110V / 220V )
* Computer data output, can cooperate with optional USB Cable/USB-01,
RS232 cable/UPCB-02 and Data Acquisition software, SW-U811-WIN.
* Optional type K probe: TP-11.
1
To Next Page
Loading...
