Bolt™ Jr+ Quick Start Guide
35
6. VIDEO 1 OUT connector for the video 1 signal from the camera.
This has a straight-through connection to the VIDEO 1 IN
connector (2).
7. VIDEO 2 OUT connector for the video 2 signal from the camera.
This has a straight-through connection to the VIDEO 2 OUT
connector (3).
9. ROBOT ONLY connector. You use this to connect the CR800 unit
(inside the Bolt Jr+ Base) to the hub via the umbilical cable.
10. E STOP connector. You connect this to the E-stop button beside the
computer stack, via the umbilical cable.
To Next Page
Loading...