Contents
1 Safety Regulations 5
1.1 Correct Use 5
1.2 Liability Information 5
1.3 Application, Advice, and Restrictions 5
2 Description 7
2.1 General 7
2.2 Principle of Operation 7
2.3 Technical Specification 8
3 Installation 10
3.1 Installation-Step by Step 10
3.2 Unpacking 10
3.3 General Installation Instructions 10
3.4 Recommended Torque and Terminal Sizes 11
3.5 Electrical Connection to the Control Unit 11
3.5.1 Junction Box Terminals 11
3.5.2 Maximum Cable Length 11
3.6 Electrical Connections 12
4 Start up 13
5 Maintenance and Service 14
5.1 Calibration 14
5.1.1 Zero Calibration 14
5.1.2 Span Calibration 14
5.1.3 Calibration with Accessories 15
5.2 Sensor Replacement 15
5.3 Series 47K-PRP and Series 47K-HT-PRP 15
5.3.1 47K-HT-PRP 16
5.3.2 47K-PRP 16
6 Accessories 18
6.1 Calibration Cap 18
6.2 Weather Protection Cap 18
6.3 Flow Through Adapter/ Pump Adapter 19
6.4 Duct Mount Flange 19
6.5 Pipe Mounting Kit 20
6.5.1 Mounting Kit for Pipes with a Diameter of up to 50 mm 20
6.5.2 Mounting Kit for Pipes with a Diameter from 50 mm up to 150 mm 21
6.6 Remote Calibration Adapter (CalGard) 21
6.6.1 Installation 22
6.6.2 Operation 22
7 Markings, Certificates, and Approvals 24
7.1 According to the Directive 2014/34/EU [ATEX] 24
7.1.1 Series 47K PRP, Series 47K-HT-PRP 24
7.1.2 Junction Box Typ S47K and X Series AL Junction Box 25
7.2 According to IECEx 26
7.3 Special Conditions for SIL 2 According to TUV Certificate 968 / EZ 392.00/09 26
8 Ordering Information 28
3 Series 47K GB
To Next Page
Loading...
Need help?
General
