Fire-fighting Helmets / Preventive care, control
and maintenance
3a) Standard Cradle
Take out the cradle by unlocking first the front and rear clips
from their locations, then taking out the side clips which
locating groove is larger.
Always start with side clips when reassembling the cradle.
The headband can be unlocked with the velcros.
3b) Ratchet cradle
Unlock the cradle on the front (2 points – a) and on the rear (2
points – b)
4a) Soft padding (L)
Remove the padding carefully to avoid tearing it.
When re-installing the soft padding, place the smaller / thinner part in the front, the 2
centering blocks of the rear must be placed inside the shell comb. The correct position is
reached when the rear part is positioned on the edge of the inner shell.
4b) Rigid padding
Check the padding is not «glued » by the silicon of the ear
plates. If this occurs, cut the silicon using a cutter.
Remove the padding using the inner shell on the side. Open
the shell to remove the padding easily.
Version 7a/ May 2010 Page 22/36
To Next Page
Loading...
