Fire-fighting Helmets / Preventive care, control
and maintenance
CONFORMITY CRITERIA FOR F2 COMPONENTS
Control procedure
The control should be performed following the order mentioned below.
Before proceeding, check that the helmet includes only original / Gallet parts.
Components of F2 helmet
1
Shell – GA3002
4
Complete F2 cradle – GA3005
2
PSE padding - rigid – GA3015
5
Complete F2 chinstrap – GA3003
3
PE padding - soft – GA3011
6
F2 Protection goggles – GA3007
List of conformity criteria
1) Helmet Shell
If the shell is cracked : change the shell,
If the shell has been drilled during a previous repair operation or to add a non
certified element : change the shell,
If there is a significant bump on the shell (that can be felt from the inside) : change the
shell
.
If paint is missing on more than 1 cm
2
(single piece): change the shell.
2) Rigid inner padding (PSE)
If the padding is cracked or broken : change the padding.
Version 7a/ May 2010 Page 33/36
To Next Page
Loading...
