Fire-fighting Helmets / Preventive care, control
and maintenance
Kit Fix positionning on the shell side
Assembly of accessory interfaces (lamp interface)
References
GA1461 – Interfaces for accessories (L+R)
1. Place the interface in front of the attachment points in the shell (step 1)
2. Insert the rear attachment until you can clip the front part (steps 2 and 3).
3. Check the interface and the shell are well secured (step 4)
4. Repeat for the other side.
Step 1 :
Step 2
Version 7a/ May 2010 Page 27/36
To Next Page
Loading...
