Fire-fighting Helmets / Preventive care, control
and maintenance
• Same procedure as 1-4-1.
Caution : losing an insert can occur after a strong impact / shock on the helmet. It is then
strongly recommended to inspect carefully the helmet and the shell.
1-5 – Mask attachment (F1 and F1S)
If the mask attachment is cracked, broken or unclipsed : replace it (use silicon
when installing the new hearing plate)
1-6 – Front plate (all models)
If the front plate is getting dirty, it is not necessary to change it, except for aspect issues.
2) Control of visors, axes and knobs (all models)
Definition of face shield areas
Version 7a/ May 2010 Page 16/36
Sensitive area of F1 face shield (A and C)
d
d
d
d
area A (d = 1cm)
Lower and upper
rims = area C
Ocular area (band) (B)
Band B (3 cm)
To Next Page
Loading...
