MSA F1S - Conformity Criteria for F2 X-TREM Components; Control Procedure for F2 X-TREM; Ratchet and Chinstrap Control

Fire-fighting Helmets / Preventive care, control
and maintenance
CONFORMITY CRITERIA FOR
F2
X-TREM COMPONENTS
Control procedure
The control should be performed following the order mentioned below.
Before proceeding, check that the helmet includes only original / Gallet parts.
1. F2 X-TREM shell
GA3220
2. Shell straps GA3222
3. Ratchet cradle GA3223
dont
4. Headband GA3224
5. Rear Interface GA3227
6. Net GA1012F
7. Front Interface GA3225
8. Chinstrap GA3226
• Remove the neck pads to release the chinstrap attachment (change the neck pad if
unsewed and/or torn.
• Open the chinstrap to access the inner elements
• Release the rear attachment of the chinstrap (push down and rotate 1/4)
Control the ratchet and chinstrap
Unlock the cradle (2 clips in the front, 2 clips in the rear)
If one of the clip is damaged : change the headband
If the headband is torn : change the headband
If the net is torn : change the net
Version 7a/ May 2010 Page 35/36