Fire-fighting Helmets / Preventive care, control
and maintenance
Chinstrap installation
Unassembling
: Rotate the strap by 180° (a), pull (b) out of
the location (c). Unlock the buckle to take the chinstrap out
of the rear point.
Assembling
: Put the clip in its location (a) and pull (b)
Attach both parts of the chinstrap with the rear strap sliding it
through the multifix fixture.
Caution : the chinstrap strap must go under the (spider)
harness
Installation of the ratchet cradle
Clip the red cradle tensionning device in the multifix fixture (2
points) at the rear of the shell.
Clip the ratchet headband in its locations (front in the inner
shell, rear in the red tensionning device).
Version 7a/ May 2010 Page 25/36
To Next Page
Loading...
