1. If harness has PFL tunnel—
use PFL tunnel as connection
point.
2. Unclip plastic divider on V-TEC
TwinLink connector. Rotate, lift, and
twist gate on carabiner. Push gate
inward to open carabiner.
3. Feed carabiner through swivel eyelet
on first V-TEC PFL.
4. Feed carabiner through PFL tunnel or behind both straps on harness.
5. Feed swivel eyelet of second V-TEC PFL onto carabiner and allow
carabiner gate to snap shut. Rotate plastic divider and clip it into position to
maintain separation of PFLs.
6. If harness has PFL tunnel—
Installation complete.
If harness does not have PFL tunnel—
Pull harness straps back through
dorsal pad to eliminate slack in
webbing.
4 Harness Attachment
10 V-TEC® PFL US
To Next Page
Loading...
