MSA V-TEC PFL - Harness Attachment; Attach V-TEC Single Leg PFL to Harness; Attach Twin Leg PFLs with TwinLink Connector

PFL Materials
Component Standard Material
Case Polycarbonate
Drum Stainless Steel / Nylon
Chassis, Pawl, Swivel Assembly,
Main Spring
Stainless Steel
Lifeline 2/3" (17 mm) wide / 0.06" (1.4 mm) thick
HMPE
Connectors Steel OR Aluminum
4 Harness Attachment
WARNING!
DO NOT rely on feel or sound to verify proper connector engagement. Ensure the
connector is closed before use.
Failure to follow this warning can result in serious personal injury or death.
4.1 Attach V-TECSingle Leg PFLto Harness
A V-TEC PFL may be connected to an approved full body harness by feeding the
carabiner through the back D-ring of the harness. In these applications, the
snaphook is connected to a suitable anchorage with the appropriate connecting
hardware.
4.2 Attach V-TECTwinLeg PFLs to Harness with V-TECTwinLink
Connector
A V-TEC TwinLink connector can be used to connect two V-TEC PFLs side-by-side
on a full body harness just below the rear D-Ring or through the PFL tunnel. The V-
TEC TwinLink connector shall only be used to connect a maximum of two V-TEC
PFLs to the harness.*
* The V-TEC TwinLink (minus the clip) may be used to attach directly to a full body harness D-ring.
4 Harness Attachment
US V-TEC® PFL 9