MSA V-TEC PFL - Product Specification

Inspection/Removing Product From Service
l
PFLs that have arrested a fall or are unable to pass an inspection shall be
tagged “UNUSABLE” and disposed of in accordance with local regulations.
l
Due to the nature of some fall arrest events, it is possible for the energy
absorber to not deploy. In the event that a PFL is subjected to fall arrest
forces and the energy absorber does not deploy, the PFL still must be
removed from service and marked as “UNUSABLE” until it has been
destroyed.
l
If the load indicator is deployed, immediately remove the PFL from service
and mark it as “UNUSABLE” until it has been destroyed.
Failure to follow these warnings can result in serious personal injury or
death.
3 Product Specification
System Requirements
Component ABNT IRAM
Anchorage
Connector Standard
NBR 16325:2014 IRAM 3605
Harness Standard NBR 15836:2020 IRAM 3605
Connectors
Standard
NBR 15837:2020 IRAM 3605
Retractable Type
Fall Arresters
NBR 14628:2020 IRAM 3605
Structure Strength 12 kN 12 kN
Energy Absorber NBR 14629:2020 IRAM 3605
NOTE: The product may comply with standards shown. See product label for
specific compliance information. Those designated with a certification mark are
listed with the corresponding agency as compliant to the applicable standard.
3 Product Specification
8 V-TEC® PFL US