3-16
MS-6585 ATX Mainboard
Initalize VGA BIOS By S3
Selecting Enabled will make BIOS call VGA BIOS to initialize the VGA card
when system wakes up (resume) from S3 state. The system resume time is
shortened if you disable the function, but system will need AGP driver to
initialize the card. Therefore, if the AGP driver of the VGA card does not
support the initialization feature, the display may work abnormally or not
function after resuming from S3.
Power Button Function
This feature sets the function of the power button. Settings are:
Power Off The power button functions as normal power off button.
Suspend When you press the power button, the computer enters
the suspend/sleep mode, but if the button is pressed for
more than four seconds, the computer is turned off.
After AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
Off Leaves the computer in the power off state.
On Leaves the computer in the power on state.
Last State Restores the system to the previous status before power
failure or interrupt occurred.
Set WakeUp Events
Press <Enter> and the following sub-menu appears.
USB Wake Up From S3
This item allows the activity of the USB device to wake up the system
from S3 (Suspend to RAM) sleep state. Settings: Enabled, Disabled
To Next Page
Loading...
