Chapter 4 - BIOS Setup
4-7
IDE Channel 0/1 Master/Slave
Press <+> or <-> to select the hard disk drive type. The specification of harddisk
drive will show up on the right hand according to your selection. Press <Enter> for
the sub-menu of each item:
IDE HDD Auto-Detection
Press Enter to allow BIOS to auto-detect the type of the HDDs.
IDE Channel 0 Master
Press PgUp/<+> or PgDn/<-> to select Manual, None or Auto type. Note that the
specifications of your drive must match with the drive table. The hard disk will
not work properly if you enter improper information for this category. If your
hard disk drive type is not matched or listed, you can use Manual to define your
own drive type manually.
If you select Manual, related information is asked to be entered to the following
items. Enter the information directly from the keyboard. This information should
be provided in the documentation from your hard disk vendor or the system
manufacturer.
Access Mode The settings are CHS, LBA, Large, Auto.
Capacity The formatted size of the storage device.
Cylinder Number of cylinders.
Head Number of heads.
Precomp Write precompensation.
Landing Zone Cylinder location of the landing zone.
Sector Number of sectors.
To Next Page
Loading...
